Adjustable Probe Mount Acrylic This will not work with

This will not work with the v2 motor mounts

5mm or thicker flexplate as our magnets are very strong (N48SH rated for 150C and 11lbs holding force) and can cause thinner sheets to dimple in the area of the magnets

2 Cap Head m3x20mm bolts used to lock the bed to the adapter plate if you have to flip your printer to work on it

The magnets are recessed slightly below the surface of the bed

These beds have been optimized to work on the mounting points for the Voron 2

Adjustable Probe Mount Acrylic This will not work withA mount for the StrykePoint Probe and BLTouch Probe! Our goal was to produce a mount that was rigid as well as adjustable. No more need for spacers! It is compatible with all of the various Y carriages available for the Railcore but should be easily mountable to most other carriages. Even the Hemera Y Carriage on the hotend side. We are working on a new mounting solution for machined mount for the rear mount position. The adjustable probe mount comes